• Home
  • Products
  • CUT
    • NO HF Non-touch Pilot Arc Plasma Cutting Machine
    • NO HF Non-touch Pilot Arc Plasma Cutting Machine
    CUT-45 65 85 105 125

    NO HF Non-touch Pilot Arc Plasma Cutting Machine

    Product Details

    ●Product Parameters

    MODEL CUT-45PRO CUT-65PRO CUT-85PRO CUT-105PRO
    Rated Input Voltage(VAC) 1P 140-270V 1/2/3P 220/380V
    Rated Input Power(KVA) 4.9 7.3 11 14.5
    Max Input Current(A) 34 15 20 28
    Duty Cycle(%) 60 60 100 100
    No-Load Voltage(V) 330 350 400 420
    Adjustable Current Range(A) 10~45 10~65 20~80 20~100
    Arc lgnition Mode NO HF, untouch NO HF, untouch NO HF, untouch NO HF, untouch
    Gas Pressure Range(Mpa) 0.3~0.6 0.3~0.6 0.3~0.6 0.3~0.6
    Quality Manual Cutting Thickness(MM) 12 20 30 45
    MAX Manual Cutting Thickness(MM) 20 32 45 60
    Net Weight(KG) 7.3 12 2605 30.5
    Machine Dimensions(MM) 407*160*280 600*230*460 600*230*460 670*325*605

    ●Assemble the cutting torch correctly

    Install the torch correctly and carefully, making sure all parts fit together well and that gas and cooling air flow. Installation Put all the parts on a clean flannelette to avoid dirt sticking to the parts. Add proper lubricating oil to the O-ring, subject to the brightening of the O-ring, do not add more.

    ● Consumable parts should be replaced in time before they are completely damaged

    Do not replace consumable parts after they are completely damaged, because severely worn electrodes, nozzles and swirl rings will produce uncontrollable plasma arcs, which can easily cause serious damage to the cutting torch. So when you first notice that the cutting quality has declined, you should check the consumables in time.

    ● Clean the connecting thread of the cutting torch

    When replacing consumable parts or daily maintenance and inspection, be sure to ensure that the inner and outer threads of the torch are clean, and if necessary, clean or repair the connecting thread. the

    ● Clean the contact surface of the electrode and the nozzle

    In many cutting torches, the contact surface between the nozzle and the electrode is a charged contact surface. If there is dirt on these contact surfaces, the torch cannot work normally and should be cleaned with a hydrogen peroxide cleaning agent.

    ● Check gas and cooling air every day

    Check the flow and pressure of gas and cooling air every day. If insufficient flow or leakage is found, stop the machine immediately to troubleshoot.

    ● Avoid torch collision damage

    Check the flow and pressure of gas and cooling air every day. If insufficient flow or leakage is found, stop the machine immediately to troubleshoot.

    ● Avoid torch collision damage

    In order to avoid collision damage to the cutting torch, it should be programmed correctly to avoid the system from overrunning. Installing an anti-collision device can effectively avoid damage to the cutting torch during collision.

    ● The most common causes of torch damage

    (1) Torch collision.
    (2) Destructive plasma arc due to damage to consumable parts.
    (3) Destructive plasma arc caused by dirt.
    (4) Destructive plasma arc caused by loose parts.

    ● Precautions

    (1) Do not grease the torch.
    (2) Do not overuse O-ring lubricant.
    (3) Do not spray anti-splash chemicals while the protective sleeve is still on the torch.
    (4) Do not use a manual cutting torch as a hammer.